DynaVap VapCap M 2021

Like all DynaVap devices, it uses click-cap technology: heat the tip with a jet lighter until the cap clicks audibly — that's the signal to inhale. After cooling (5-8 seconds) it clicks again, ready for the next cycle.

Temperature varies with technique: heating closer to the cap end gives lighter vapor, closer to the tip gives denser clouds. Expect 3-5 heat cycles per fill. For a flameless alternative, induction heaters like the YLL 3.0 or the Ispire Wand work well.

The M 2021 uses convection — hot air flows through the material during inhalation. The vapor path is short and direct. Flavor is clean and metallic, typical of stainless steel.

No airport, no airflow adjuster. Draw resistance is fixed and moderate. For many users that's a plus: no settings needed, works right away.

The tip has no Adjust-A-Bowl — chamber holds about 0.1 g always. For smaller amounts, just fill less.

The M 2021 is not compatible with dosing capsules. Fill material directly into the tip, loosely packed.

The M 2021 has a 10mm fitting and connects directly to standard water pipes. Water-filtered vapor is cooler and smoother.

For 14mm bongs, use an adapter. The M 2021 + bubbler combo is popular — affordable entry with good vapor quality.

Brush the tip after each session. Weekly: disassemble tip, condenser, and cap, soak in isopropanol (90%+). Lubricate O-rings with DynaWax.

Don't soak the cap in iso — only the metal body. The click mechanism isn't damaged by moisture, but alcohol can affect the coating. Clean the cap separately with a dry cloth.

Included: VapCap M 2021, DynaWax (O-ring lube), and cleaning brush. No lighter included — a jet lighter must be purchased separately.

DynaVap recommends a single-flame jet lighter for precise heating. Budget butane lighters start at about €5.

The M 2021 is the toughest and simplest DynaVap. Budget entry with torch: The B2. Wood and titanium: VonG.

• DynaVap Official