Koil Boi Storm

The Koil Boi Storm delivers heating power specifically tuned for DynaVap devices. The induction coil generates enough energy to bring a standard stainless steel cap to click temperature in 5 to 7 seconds. Titanium caps respond faster and reach the click in about 4 seconds. The 2600 mAh battery supports roughly 60 to 70 heat cycles per charge, covering several days of typical daily use. A single button starts the heating process and stops it automatically after 12 seconds as a safety measure. The opening at the top is sized to accept the Vapcap M, Omni, and BB models without an adapter.

The Storm earns its name: the shell is made from impact-resistant polycarbonate with rubberized grip zones on the sides. This combination protects internal electronics during falls from table height and provides a secure hold with wet hands. The USB-C charging port sits behind a silicone flap that keeps out dust and water splashes. While the Storm is not meant for underwater use, light rain or outdoor humidity pose no problem. Total weight of 185 grams stays low enough to carry the device in a trouser pocket. The manufacturer provides a two-year warranty on the induction motor and one year on the battery.

The Koil Boi Storm weighs 185 grams and fits into any jacket pocket. Its polycarbonate shell survives table-height drops without issue. Rubberized grip zones on both sides prevent slipping with damp hands. For travel, it works better than most stationary induction heaters since no separate power supply is needed.

The Koil Boi Storm delivers consistent induction heating across sessions thanks to its regulated power output. Insert your DynaVap, press the button, and wait for the click — no technique required unlike torch heating. The built-in battery handles 30-40 heat cycles per charge. USB-C charging takes about 2 hours. The flat base lets you stand it on a desk between uses. Works with all standard DynaVap models including the M and Omni series.